ZETRON 360 Manual de Instruções descarregar pdf (Página 23)

Radio Programming

Note

Due to differences in various versions of the radio programming

software, some settings may have slightly different names and

may be located in different windows or tabs than those shown

here. The specific software shown here is “KPG111D” v2.10.

 To configure a NX-800 radio for basic settings:

1. From the Edit menu, select Optional Features and Optional Features 1. On the

Common Page 1 tab, mark the Off-hook Decode check box.

Off-hook Decode causes the transceiver to open the squelch for valid channel

activity regardless of the Mic Hook On/Off status. This is important if using QT

(CTCSS) or DT (DCS); otherwise the radio would not unsquelch if a signal was

present and the hand microphone was removed or not grounded in its hanger.

2. Go to the Common Page 3 tab of the Optional Features 1 configuration window:

a. Set the function assignment for COM Port 0 and COM Port 1 to None.

b. Assign COM Port 2 to Data, Normal polarity, 2 stop bits and a Baud rate

of 9600.

c. Set PC Interface Protocol to Version 1.

The Model 360 connects to COM Port 2 via the DB-25 connector on the back of

the radio.

Details regarding the use and interaction of the port settings for COM 0, 1, and 2

are discussed in the radio’s programming manual and can be accessed by clicking

Help.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 76 77

Sem comentários

ZETRON 360 Manual de Instruções Página 23