ZETRON 360 Manual de Instruções descarregar pdf (Página 15)

Radio Programming

TK-x80 Series Radio Programming

Note

When configuring a radio, the technician should start by setting

the radio to its default values and then change/verify the

parameters specifically mentioned in this manual.

The settings called out in the manual are required. Those

settings not mentioned should be left at their default values. This

will give you a basic configuration that is known to work.

Note

Due to differences in various versions of the radio programming

software, some settings may have slightly different names and

may be located in different windows or tabs than those shown

here. The specific software shown here is “KPG-49D” v4.01.

 To configure TK-x80 series radio programming for basic settings:

1. Bring the external microphone input to the radio’s KCT-19 cable by removing

R94 and shorting across the pads of R24 in the radio.

2. Install the KCT-19 cable according to the directions in the Kenwood installation

manual. Be sure to plug connector E on the KCT-19 cable into CN4 in the radio.

3. Using the radio’s configuration software, set the following parameters for proper

use with the Model 360 Radio Interface Module.

4. In the Optional Features menu:

• COM1 = Data

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 76 77

Sem comentários

ZETRON 360 Manual de Instruções Página 15