ZETRON 2000 Series Especificações descarregar pdf (Página 222)

System Configuration Files

222 025-9035AA

Table 28: Trunk Card OPARAM Codes (continued)

(**) = default value for parameter

Meaning cc pp qq ...

Dial Click Timing

(applies to dual trunk only)

03 15 (“cc = 03” is for newer Dual Trunk codes, Rev. 6d4 and

later.)

byte 1 = NOZONE - ignore click events this long after

click. Default: 12 ms (0C hex)

byte 2 = OKZONE - wait this long after NOZONE for

another click to occur. Default: 94 ms (5E hex)

Notes: 1. Programming a 0 for any dial click value

leaves the setting on the dual trunk card

unchanged.

2. If the dial click option card is not installed, an

“opcode error” (01) will result.

3. Default dial click parameters provide 8 to 11

pps with 58% to 64% break.

Disable owner’s access

(DTMF 0)

02 24 **00 off - DTMF 0 is reported

01 on - DTMF 0 will not be reported during a prompt

02 DTMF 0 will be remapped

DTMF * options 02 27 **00 = “normal” handling of DTMF *

01 = DTMF * will always be interpreted as a dash “-”

02 = same as 01, except a ** digit(s) sequence will be

interpreted as a canned message lookup instead of

two dashes

DTMF minimum digit time

Alternate:

1F byte 1 = minimum time DTMF digit must last before it

is considered valid, less time and it will not be

reported (40 ms default).

byte 2 = 01-Enable, 00-Disable, DTMF suppression

byte 1 = same as byte 1 above

Enable the MF Decode

Option

1B **00 = decode either pulse or DTMF feed digits

01 = decode only MF digits

20 = decode MF R2 sequence A

21 = decode MF R2 sequence B

02 nn = FGC MF feed digits.

03 nn = FGD MF feed digits.

04 nn = option 1 + option 3 (If only the number of feed

digits specified in line type arrive in the first

feed received, call progresses as an 01-type

feed.)(If additional digits are received, the string

is assumed to be an ANI and the terminal looks

for a second feed.)

22 nn = MF R2 sequence C

23 nn = MF R2 sequence D, nn is the number of COS

digits in the ANI feed (nn_9)

20 nn nn = decode MF R2 sequence A

byte 1 = valid number in range = 06

byte 2 = invalid number range = 05

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 375 376

Comentários a estes Manuais

Sem comentários

ZETRON 2000 Series Especificações Página 222

Comentários a estes Manuais

Manuais e produtos relacionados com Terminais POS ZETRON 2000 Series